Compatible with 1 in (25 mm) webbing

Side-Release Snap Buckle Pair (1 in)

Coming soon

Two side-release buckles for 1 in webbing, printed flat for strength. Replace a cracked buckle on a strap, pack or dry bag.

Not for sale yet. We're test-printing it and fitting it on real gear first.

One email when this part goes on sale. Nothing else.

About this part

Snapped buckles retire a lot of good straps. These are printed flat so the layers run along the load, which makes them stronger than most printed buckles.

Sold as a pair for 1 in (25 mm) webbing. 3/4 in and 1-1/4 in sizes are possible on request.

Specs

Material
ASA
Colors
Black
Size of one part
53 × 32 × 10 mm
Weight (estimated)
About 11 g
Fits
1 in (25 mm) webbing

Install

  1. Thread the webbing through each half's bar.
  2. Snap the halves together until both arms click.

Questions

Is it rated for loads?
No. Use it on gear straps and bags, not for climbing, towing or anything that holds a person.

Design credit

This part is printed from Strong Printable Snap Buckle by squinn, licensed under CC BY 4.0. Thank you to the designer for sharing it.

We print it as published, with no changes to the design.